Caple Oi360SS User Manual download pdf (Page 4)

* The appliance is not intended for use by young children

or infirm persons without supervision. Young children should

be supervised to ensure they do not play with the appliance.

* The cooker surface and the inferior part of the cooker

hood must be at a minimun distance of 65 cm.

* The air sucked can't be conveyed through or into a

duct used to let out fumes from appliances fed by

energy other than electric power (eg. centralized

heating, radiators, water-heaters, etc.).

* To evacuate the air outlet, please comply with the

pertaining rules given by competent authorities.

* Provide the room with an adequate aeration when a

cooker hood and appliances fed by energy other than

electric power (gas-, oil-, or coal- stoves, etc.) are used

simultaneously. The cooker hood, when evacuating the

sucked air, could generate a negative pressure in the

room- which can't exceed the limit of 0.04 mbar, in

order to avoid the suck of exhausts deriving from the

heat-source. Therefore the room should be provided

with air-intakes to allow a costant flow of fresh air.

If the rating lable in the cooker-hood shows

the symbol , the appliance is built in class

II° and it does not need any earth connection.

If the rating lable in the cooker-hood does not

show the symbol , the appliance is built in

class I° and it needs the earth connection.

* When performing the electrical connections on the

appliance, please make sure that the current-tap is

provided with earth connection and that voltage values

correspond to those indicated on the label placed inside

the appliance itself.

* Before carrying out any cleaning or maintaining operations,

the appliance needs to be removed from the electric grid. If

the appliance is not provided with a non-separable flexible

cable and plug, or with another device ensuring omnipolar

disconnections from the grid, with an opening distance

between the contacts of at least 3 mm, then such disconnecting

devices must be supplied within the fixed installation.

If the fixed appliance is endowed with a supply cord and

a plug, the appliance has to be put in a place where the

plug can be reached easily.

* The use of materials which can burst into flames should

be avoided in close proximity of the appliance. When

frying, please pay particular attention to fire risk due to

oil grease. Being highly inflammable, fried oil is especially

dangerous. Do not use uncovered electric grills.

WARNINGS

USES

* Before installing the appliance, in order not to damage

the appliance itself, the metal grase filter should be

removed. Such filter can be removed by pushing the

special filter handle toward the back side of the cooker

hood and turning it downwards so to unfasten it from

its slot (Fig.3B-4A).

Wall stirrup-fixing

* By using the special drilling jig (Fig.5X), perforate the

wall according to the pattern indicated by the jig itself,

and pay attention in order not to damage water pipes

and electric wires. Perforation should be performed

with a Ø 8 mm wall-drill. Then insert into the proper

plastic reinforcements (Fig.5A). The hood-bearing stirrup

(Fig.5S) can be applied by using the screws provided

with the equipment (Fig.5B). Now hook the cooker hood

onto its bearing (Fig.7) and then adjust horizontally and

vertically the position of the appliance by acting on the

special metric screws (Fig.9V,T).

After the appliance is adjusted, fix it by inserting and

tightening the safety screws properly (Fig.5C) Mod. SM

- SL. On the modular models standard and luxury

version, after fixing the angle iron on the wall (Fig.6C),

hang the module to the appropriate bracket (Fig.6S).

Adjust and block with the screws supplied (Fig.9V-T).

Insert the screws to block the module (Fig.8A).

Fixing the ornamental chimney

* Before fixing the chimney, place the electric feeding

equipment into the ornamental pipe and provide it with

a hole for the air outlet if the appliance is used in its

sucking version.

The appliance is already arranged both for filtering and

for suction performances.

* In its filtering version (Fig.1), the air and fumes conveyed

by the appliance are depured both by a grease filter and

by an active coal filter, and put again into circulation

through the side-grids of the chimney. For this version

an air deflector placed on the superior part of the pipe

and allowing air-recycling is necessary (Fig.1A).

* In its sucking version (Fig.2), fumes are directly

conveyed outside, through an evacuation duct connected

with the superior part of the wall or the ceiling. Both coal

filter and air deflector are not necessary in this case.

INSTALLATION

In order to avoid possible fire risk, all instructions for

grase-filter cleaning and for removing eventual grease

deposits should be strictly followed.

1 2 3 4 5 6 7 8 9 10 11

Comments to this Manuals

No comments

Caple Oi360SS User Manual Page 4

Comments to this Manuals

Related products and manuals for Hoods Caple Oi360SS