NOTE: Please read all instructions carefully before using this product Safety Notice Hardware Identifier Assembly Instruction Parts List Re
STEP 5 (See Diagram 5) A.) Attach the Right Butterfly (#9) to the Upper Frame (#10). Slide a ∅1 ½” Washer (#51) and ∅1 3/8” Steel Cap (#84) onto
CABLE LOOP DIAGRAM 10
STEP 6 (See Diagram 6 & Cable Loop Diagram) A.) Insert the 110” Upper Cable (#30) through the opening at the front of the Upper Frame (#10). NOT
STEP 7 (See Diagram 7 & Cable Loop Diagram) A.) Attach a Pulley (#79) to the bracket on the Right Butterfly (#9). Secure it with a M10 x 1 ¾” (
STEP 8 (See Diagram 8 & Cable Loop Diagram) A.) Insert the 159” Lower Cable (#31) through the opening on the bottom of the Leg Developer (#13).
STEP 9 (See Diagram 9 & Cable Loop Diagram) A.) Attach the136” Bench Press Cable (#34) to the open slot on Pulley Cable Hanger (#45) previously
STEP 10 (See Diagram 10 & Cable Loop Diagram) A.) Plug one ∅1/2” Plastic Bushing (#76) into the hole on the side of the Rear Vertical Beam (#4)
STEP 11 (See Diagram 11) A.) Attach the Seat (#28) to the Seat Support (#12). Secure it with two M8 x 2 ½” Allen Bolts (#103) and ∅ 5/8” Washers (#
HOW TO USE How to use the quick release connector. The Clip is removed from the Connector. Connector Clip Place the chain in between the c
TABLE OF CONTENTS BEFORE YOU BEGIN... 1 IMPORTANT SAFETY NOTI
Parts List KEY NO. DESCRIPTION Q’ty 1 Base Frame 1 2 Rear Stabilizer 1 3 Front Vertical Beam 1 4 Rear Vertical Beam 1 5 Top Socket Assembly
IMPEX INC. LIMITED WARRANTY IMPEX Inc. ("IMPEX") warrants this product to be free from defects in workmanship and material, under normal
IMPORTANT SAFETY NOTICE PRECAUTIONS This exercise machine is built for optimum safety. However, certain precautions apply whenever you operate a
ASSEMBLY INSTRUCTION Tools Required to Assemble the Machine: Two Adjustable Wrenches and Allen Wrenches NOTE: It is strongly recommended this machi
STEP 2 (See Diagram 2) A.) Attach the Front Press Base (#7) to the Base Frame (#1). Align the holes and insert through a M10 x 9 5/8” Axle (#38).
STEP 3 (See Diagram 3) A.) Attach the Seat Support (#12) to the Leg Developer Holder (#118). Secure it with three M10 x 5/8” Allen Bolts (#102) a
STEP 4 (See Diagram 4) A.) Slide two Rubber Bumpers (#70) onto the two Weight Plate Guide Rods (#19). Insert the two Rods into the holes on the Bas
Comments to this Manuals