GW-25
GLASS/WINDOWS/MIRRORS
Rear Door Glass
B: INSTALLATION
1) Install in the reverse order of removal.
CAUTION:
Make sure that glass stay is placed securely in
sash.
2) Adjust the rear door glass. <Ref. to GW-25, AD-
JUSTMENT, Rear Door Glass.>
Tightening torque:
Refer to “COMPONENT” of “General Descrip-
tion”. <Ref. to GW-5, REAR DOOR GLASS,
COMPONENT, General Description.>
C: ADJUSTMENT
NOTE:
The rear door glass, as a rule, should be adjusted
in the same manner as front door glass, although
they are different in dimension. <Ref. to GW-12,
ADJUSTMENT, Front Door Glass.>
1) Adjust the glass position using the following di-
mensions as a guide line.
NOTE:
• If dimensions are smaller than the given dimen-
sions, glass may get caught in weather strip during
lifting/lowering operation and may not be fully open.
• After adjustment, move the glass up and down to
check whether it is caught.
2) Install the ST to glass and adjust the glass adhe-
sion to the value shown.
ST 61299AE010 SPACER (Glass thickness: 4
mm (0.157 in) for rear door
glass)
NOTE:
• If rear glass adhesion is higher than necessary,
glass may get caught in weather strip of center pil-
lar corner, resulting in early wear of weather strip.
Care should be taken for adjustment.
• After adjustment, move the glass up and down to
check whether it is caught.
(1) 11 mm (0.433 in)
AA
A-A
(1)
(1)
GW-00067
(1) 3.2 — 4.8 mm (0.126 — 0.189 in)
(2) 3.0 mm (0.118 in): when replacing weather
stripe with a new one
5.5 mm (0.217 in): when re-using weather
stripe
(3) ST
A
A
A-A
GW-00337
(2)
(1)
(3)
Comments to this Manuals