LI-10
LIGHTING SYSTEM
Combination Base Switch Assembly
9. Combination Base Switch
Assembly
A: REMOVAL
1) Remove the driver’s airbag module. <Ref. to AB-
16, REMOVAL, Driver’s Airbag Module.>
2) Remove the steering wheel. <Ref. to PS-14, RE-
MOVAL, Steering Wheel.>
3) Remove the screws and remove the steering
column lower cover.
4) Remove the combination switch. <Ref. to LI-9,
REMOVAL, Combination Switch (Light).> <Ref. to
WW-6, REMOVAL, Combination Switch (Wiper).>
5) Remove the four screws and remove the roll
connector.
6) Remove the three screws.
7) Disconnect the connector and remove the com-
bination base switch assembly.
B: INSTALLATION
1) Install in the reverse order of removal.
2) Before installing steering wheel, be sure the di-
rection of roll connector is adjusted with steering.
<Ref. to AB-25, ADJUSTMENT, Roll Connector.>
C: INSPECTION
1. COMBINATION BASE SWITCH ASSEM-
BLY
Inspect the combination base switch assembly and
roll connector for crack or deformation. If any dam-
age is found, replace with a new one.
2. PARKING SWITCH
Measure the resistance between parking switch
terminals.
SL-00258
LI-00271
Switch position Terminal No. Standard
OFF 2 and 4 Less than 1 Ω
ON 1 and 4 Less than 1 Ω
LI-00183
12
34
Comments to this Manuals