Caple Wi151 Specifications Page 90

  • Download
  • Add to my manuals
  • Print
  • Page
    / 101
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 89
GW-14
GLASS/WINDOWS/MIRRORS
Front Door Glass
7) After adjusting the clearance between center pil-
lar, up and down the glass several times to check
glass contact to stopper when glass is fully closed.
Adjust it to contact the front and rear stopper simul-
taneously.
8) For adjustment of the upper and lower ends of
center pillar, loosen the adjusting nut (A) of B-chan-
nel (B).
9) For glass stroke adjustment, install the ST to
glass, close the door, and raise the glass with reg-
ulator until positional relationship between glass
and weather strip becomes as shown. And secure
the glass so that the upper stopper correctly touch-
es the glass holder.
ST 61299AE000 SPACER (Glass thickness: 5
mm (0.197 in) for front door
glass)
For preventing wind noise, adjust the glass at the
position where tip of gusset is raised up a little.
10) After stabilizer adjustment, carry out the glass
cohesion adjustment. First, visually ensure the po-
sitional relationship between retainer & molding
and glass of the roof side, and then begin with rear
sash adjustment. Install the ST to glass and adjust
two adjusting bolts alternately step by step to ob-
tain dimensions shown below (cross-section A).
NOTE:
If two nuts are loosened at the same time, the sash
moves back and forth. Therefore, when one nut is
adjusted, secure the other.
(1) Narrow
(2) Wide
(3) When the stopper of door sash (rear) contacts
first
(4) When the stopper of door sash (front) contacts
first
(5) Raise B channel
(6) Lower B channel
GW-00324
(6)
(5)
(4)
(1)
(2)
(1)
(2)
(3)
(A)
GW-00269
(B)
(1) 3.2 — 4.8 mm (0.126 — 0.189 in)
(2) 3.0 mm (0.118 in): when replacing weather
stripe with a new one
5.5 mm (0.217 in): when re-using weather
stripe
(3) ST
(A) 0 — 1.5 mm (0 — 0.059 in)
GW-00336
A
A
(2)
(1)
(3)
(A)
GW-00325
Page view 89
1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 100 101

Comments to this Manuals

No comments