Caple Wi151 Specifications download pdf (Page 26)

100

101

LI-28

LIGHTING SYSTEM

High-mounted Stop Light

26.High-mounted Stop Light

A: REMOVAL

1. SEDAN MODEL

1) Disconnect the ground cable from battery.

2) Push the high-mounted stop light backward of

the vehicle (1), raise the rear portion of it (2) and re-

move the clips to remove it.

3) Remove the harness from clamp.

4) Disengage two claws (A), pull out the high-

mounted stop light from the cover and remove the

claw (B).

5) Disengage three claws and remove the lens (A).

6) Remove the bulb.

2. WAGON MODEL

1) Disconnect the ground cable from battery.

2) Detach the roof spoiler. <Ref. to EI-40, REMOV-

AL, Roof Spoiler.>

3) Remove the nuts (A), then detach the high-

mounted stop light.

B: INSTALLATION

Install in the reverse order of removal.

C: INSPECTION

1. SEDAN MODEL

1) Visually check the bulb for blow out.

2) Check the bulb specification. <Ref. to LI-2,

SPECIFICATION, General Description.>

3) If NG, replace the bulb with a new one.

2. WAGON MODEL

1) Install the high-mounted stop light to test if it illu-

minates normally.

2) If the high-mounted stop light does not illumi-

nate, replace it with a new one.

NOTE:

Since LED (Light Emitting Diode) is used for the

high-mounted stop light of wagon model, replace

the high-mounted stop light assembly when the

LED is powered off.

(1) Harness

(2) Clamp

(1)

(2)

LI-00333

(2)

(1)

LI-00334

LI-00309

(A)

(B)

LI-00310

(A)

LI-00312

(A)

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 100 101

Comments to this Manuals

No comments

Caple Wi151 Specifications Page 26

Comments to this Manuals

Related products and manuals for Small kitchen appliances Caple Wi151