Caple Wi151 Specifications download pdf (Page 9)

100

101

LI-11

LIGHTING SYSTEM

Headlight Assembly

10.Headlight Assembly

A: REMOVAL

1) Disconnect the ground cable from battery.

2) Remove the air intake duct. (When removing the

headlight RH)

3) Remove the front grille. <Ref. to EI-24, REMOV-

AL, Front Grille.>

4) Remove the front bumper. <Ref. to EI-30, RE-

MOVAL, Front Bumper.>

5) Disconnect each harness connector.

6) Remove the 5 bolts, disengage the clip, and then

detach the headlight assembly.

B: INSTALLATION

Install in the reverse order of removal.

C: ADJUSTMENT

1. HEADLIGHT AIMING

NOTE:

Aiming of this headlight can be adjusted only in the

vertical direction. It cannot be adjusted in the hori-

zontal direction.

CAUTION:

Turn off the light before adjusting headlight

beam level. If the light is necessary to check

aiming, do not turn on for more than two min-

utes.

NOTE:

Before checking the headlight beam level, be sure

of the following:

• The area around the headlight has not sustained

any accident, damage or other type of deformation.

• Vehicle is parked on a level surface.

• The inflation pressure of tires is correct.

• Vehicle’s fuel tank is fully filled.

1) Bounce the vehicle several times to normalize

the suspension.

2) Make certain that someone is seated in the driv-

er’s seat.

3) Turn the headlights on and then adjust the low

beam pattern.

LI-00273

LI-00452

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 100 101

Comments to this Manuals

No comments

Caple Wi151 Specifications Page 9

Comments to this Manuals

Related products and manuals for Small kitchen appliances Caple Wi151