LI-35
LIGHTING SYSTEM
Ignition Switch Illumination
33.Ignition Switch Illumination
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the screws and detach the upper col-
umn cover and lower column cover.
3) Remove the instrument panel lower cover. <Ref.
to EI-56, REMOVAL, Instrument Panel Assembly.>
4) Disconnect the ignition switch illumination con-
nector (A).
5) Turn the ignition switch illumination connector to
left and disconnect it.
B: INSTALLATION
Install in the reverse order of removal.
C: INSPECTION
SL-00258
(A) Ignition switch illumination connector
(B) Ignition switch illumination
(C) Immobilizer antenna connector
LI-00343
(C)
(B)
(A)
Step Check Yes No
1 CHECK IGNITION SWITCH ILLUMINATION.
Make sure the ignition switch illumination illu-
minates when driver’s side door is open.
Does the ignition switch illumi-
nation illuminate?
Ignition switch illu-
mination is normal.
Go to step 2.
2 CHECK IGNITION SWITCH ILLUMINATION.
Make sure the ignition switch illumination
blinks when ignition switch is turned to ON.
Does the ignition switch illumi-
nation blink?
Check the func-
tion setting of body
integrated unit.
<Ref. to
LAN(diag)-2, Basic
Diagnostic Proce-
dure.>
Check the ignition
switch illumination
circuit. <Ref. to
SL-20, CHECK
IGNITION
SWITCH ILLUMI-
NATION, INSPEC-
TION, Keyless
Entry System.>
Comments to this Manuals