Caple Wi151 Specifications Page 88

  • Download
  • Add to my manuals
  • Print
  • Page
    / 101
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 87
GW-12
GLASS/WINDOWS/MIRRORS
Front Door Glass
11) Remove the door glass.
CAUTION:
Since the gear may be disengaged, do not
turn regulator in the closing direction after re-
moval of the glass.
Avoid impact and damage to the glass.
B: INSTALLATION
1) Install in the reverse order of removal.
CAUTION:
Make sure that glass stay is placed securely in
sash.
2) Adjust the front door glass. <Ref. to GW-12, AD-
JUSTMENT, Front Door Glass.>
Tightening torque:
Refer to “COMPONENT” of “General Descrip-
tion”. <Ref. to GW-4, FRONT DOOR GLASS,
COMPONENT, General Description.>
C: ADJUSTMENT
NOTE:
Before adjustment, ensure that all adjusting bolts of
stabilizer, upper stopper and sash are loose and
door glass is raised so that it is in contact with
weather strip.
1) Temporarily tighten one adjusting bolt on one
side of rear sash at the midpoint of slotted hole in
the inner panel.
2) Temporarily tighten the regulator B-channel in a
position at the top of slotted hole.
3) Lower the door glass 10 — 15 mm (0.39 — 0.59
in) from fully closed position. While applying out-
ward pressure of 45.0±5.0 N (4.5±0.5 kgf, 9.9±1.1
lb) (F) to upper edge of glass above midpoint of two
outer stabilizers, press the inner stabilizer at pres-
sure of 25±5 N (2.5±0.5 kgf, 5.5±1.1 lb) to the
glass, then secure it.
4) For adjustment of clearance between front glass
and center pillar cover, loosen the nuts (A), and
move the glass sash back and forward until clear-
ance becomes the value shown.
GW-00267
(1) Fully closed position
(2) Stabilizer
(3) 10 — 15 mm (0.39 — 0.59 in)
(1) Adjust a line parallel
(2) Sash
(3) Inner panel
(1) 11 mm (0.433 in)
(1) F
(2)
A = A
A
(2)
(3)
GW-00063
A
GW-00319
(A)
(2)
(1)
(3)
GW-00064
AA
A-A
(1)
(1)
Page view 87
1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 100 101

Comments to this Manuals

No comments